USB-CNV3

USB-CNV3

$49.95
rating
  • Ex Tax:$49.95

USB interface Fuji N Series PLC (NB, NJ, NS, NW0, etc.)programming cable, USB/RS422 interface, 3 meters, with communication indicator, the largest communication distance of up to 1.5 kilometers.IntroductionUSB-CNV3 is the programming cable which USB ..

USB interface Fuji N Series PLC (NB, NJ, NS, NW0, etc.)programming cable, USB/RS422 interface, 3 meters, with communication indicator, the largest communication distance of up to 1.5 kilometers.

Introduction

USB-CNV3 is the programming cable which USB port provides serial connection and RS422 signal conversion.Under the control of driver, the programming cable simulates USB port of the computer as traditional serial port(known as COM interface) in order to use various existing programming softwares,communication softwares, monitoring softwares etc applications. The working power supply of this cable is directly from the USB port,not the PLC programming interface. The two-color LED on the converter box indicates data’s transceiving status.

USB-CNV3 is applicable to Fuji N Series (NB, NJ, NS) PLC, support the largest communication distance 1.5 km.

Functions

● Support USB-CNV3 programming software version: Flex V1.0 and above
● Fully compatible with USB V1.1 norms and USB CDC V1.1
● USB-bus powered, with current consumption of 50 mA
● Baud rate: 300 bps ~ 1Mbps automatically adapt to the standard baud rate
● Support UART data format: data bits: 7-8; stop bit: 1, 2; check-bit: odd / even / no parity
● support long-distance communication, the largest communication distance is 1.5 kilometer (19200 bps)
● Each PC only supports one USB cable programming
● Working temperature: -20 ~ +75 'C
● Cable length: 3 m; Color: black

 

Please make sure your PC is IBM PC compatible and has the following
system requirements before using the USB programming cable.
● Intel is compatible with 586DX4-100MHz CPU or higher
● A standard USB port (4-pin A plug)
● Operating system is Windows2000 or Windows XP

The setting of driver procedure
Please set the driver procedure according to the following steps:
1. Turning on PC power that will connect the USB programming cable and make sure the USB port working well.
2. Put the USB programming cable into USB port and Windows will detect the device and help to add new hardware and jump to new device setting.Insert the driver CD and click “next” to continue,

or select the driver on the hard disk.
If Windows does not show “Found New Hardware Wizard”, please click “Universal Serial bus controllers ” in the hardware list of device manager,

and choose the USB device with question mark. Click the right key of mouse and operate to update driver procedure.


Write a review

Note: HTML is not translated!
    Bad           Good